:TRIGger:SEQuence2:DELay <numeric>
:TRIGger:SEQuence2:DELay?
This command specifies the pre-measurement wait time (measurement point delay time) for each measurement point.
|
Parameter |
Value |
|
Description |
Measurement point delay time |
|
Data type |
Real |
|
Range |
0 to 1 |
|
Preset value |
0 |
|
Unit |
s (seconds) |
|
Resolution |
100E-6 |
If your specified parameter is beyond the valid range, the instrument ignores the parameter and uses either the maximum or minimum value depending on whether the parameter is greater than the upper limit or smaller than the lower limit.
{numeric}<newline><^END>
Trigger Mode > Point Delay