Open topic with navigation

3. Executing the Measurement and Viewing Results

This section introduce how to execute the envelope tracking test and how to view the measurement results. Follow the procedure below to execute the measurement and view the measurement results.

Initial Run

Timing Alignment

Executing the Measurement

Viewing the Measurement Results

Initial Run

1. Click the Run button on the tool bar to get the RF and ET waveform downloaded into the instrument and get the initial measurement results.

   

2. Once the measurement begins, the detailed information will be displayed in the Log view at the bottom of the window as shown below.

   

   During the running process, you can stop it any time by clicking the Stop button. When you see the "Complete!" message in the Log view, it indicates that the measurement is completed.

   

Timing Alignment

Timing alignment is to synchronize the input signal of the PA (the output of the RF Signal Generator) with the input voltage of the PA (the output of the Envelope Signal Generator) in time domain. There are two methods:

• Manual: Adjust the Delay and Step setting in Envelope Tracking block manually with an oscilloscope connected to the Envelop Signal Generator and RF Signal Generator and observe the signals alignment.

• Auto: Click the Auto-align ET and RF signals button on the tool bar to get the signals aligned automatically.

  

  By selecting the Pre-Align with AM-AM for Auto-Align check box in the Envelope Tracking block, you can find a possible better initial delay value with the measured AM-AM results, but this may take longer time. After the auto-alignment is finished, the Delay setting in Envelope Tracking block is updated automatically.

If the related settings (e.g. sample rate, IQ delay, trigger delay in Generator instruments, etc.) are changed and applied, it’s recommended to do the timing alignment again.

Executing the Measurement

Once a proper time alignment has completed, the signal can be played repeatedly without re-alignment. Click the Run button to play the signal and get the measurement results.

Viewing the Measurement Results

In the measurement view, there are four result windows: AM-AM, AM-PM, ACP, and EVM vs. Power. EVM vs. Power results are displayed only when Power Sweeping (in PA block) is set to On.

For ET test, ACP results are viewed. To view more detailed information, double-click on the ACP window to enlarge it as shown in the figure below.

Figure 1. ACP Results

In case you want to change the delay between envelope signal and RF signal manually, you can set the delay in the Envelope Tracking block of N7614C software and view the delay between the two signals in the oscilloscope. To view the delay between the Envelope signal and the RF signal, connect the Trig 2 output of M9311A Modulator, ETPS output and part of the RF signal (through a RF coupler) to the oscilloscope channels as shown in the figure below.