Starting and Exiting Modulation Distortion

How to start Modulation Distortion

Using Hardkey/SoftTab/Softkey

Using a mouse

1. On the VNA, press Meas > S-Param > Meas Class....

2. Select Modulation Distortion, then click OK.

3. In the Confirm Measurement Class Change dialog, click OK to proceed or Cancel to exit.

4. The Modulation Distortion application is displayed (shown below).

1. Click Instrument.

2. Select Meas Class....

3. Select Modulation Distortion, then click OK.

4. In the Confirm Measurement Class Change dialog, click OK to proceed or Cancel to exit.

5. The Modulation Distortion application is displayed (shown below).