ADC Overload Adjustment

(N9912A)
  • All adjustments will require the CFG Option. Refer to the CFG Option section for more information.
  • ADC Overload messages on the display of the UUT are expected during this adjustment.

This process determines the setting for the RF IN attenuator to ensure that power from the RF OUT port does not overload (i.e. over range) SA receiver circuits. There is one setting for each SA band.

Related test:

none

Required Test Equipment

Test Equipment

Recommended Model Number
(see main equipment list for alternative models)

Cable, Type-N (m) to Type-N (m)

11500C

 

Connection Setups

The following notes apply to illustrations in the FieldFox Help:

  • Only a single representative model will be shown.
  • Some illustrations may differ than those in TME.

  • For procedures that apply to multiple ports, illustrations will show the setup on only one test port.

ADC Overload Adjustment Setup