:CORR2:COLL

Syntax

[:SENSe]:CORRection2:COLLect[:ACQuire][:ALL] {STAN1|STAN2}

Description

Obtains the data for calculating the compensation coefficients to use during impedance measurement and the compensation coefficients to use during Rdc measurement performed with the specified standard. The data is obtained for only the active table. This command is valid only when the calibration mechanism is turned ON; otherwise, the command fails and an error is generated. (No query)

The measurement to obtain the data is not started by execution of this command. You must trigger the instrument after execution of this command when the trigger source is not set to internal trigger (Int).
The following command sequence is recommended to ensure the compensation data acquisition.

:INIT:CONT OFF
'
'
:CORR2:COLL STAN1
:INIT
*OPC?

Variable

Parameter

Param

Range

Select from the following:

STAN1: OPEN standard

STAN2: SHORT standard

Related objects

:CORR2:COLL:DC

:CORR2:COLL:RF

Equivalent key

Compen > OPEN|SHORT > AC&DC