Setting the Beeper (Built-in Speaker)

Other topics about Setting Control Functions

The E5071C has a built-in speaker that sounds a beep tone. The beeper allows you to make two types of settings.

Type

Function

Operation complete beeper

Sounds a beep tone to inform the user that operations have completed.

  • When calibration data measurements are done

  • When data storage has completed

Warning beeper

Sounds a beep tone to prompt the user to use caution.

  • When an instrument error occurs (An error message appears at the same time.)

  • When a limit test fails

 

The warning beeper sounds slightly longer than the operation complete beeper.

Setting the Operation Complete Beeper

  1. Press System key.

  2. Click Misc Setup > Beeper > Beep Complete to switch the operation complete beeper on/off.

  3. Clicking Test Beep Complete allows you to hear and check the beep tone of the operation complete beeper.

Setting the Warning Beeper

  1. Press System key.

  2. Click Misc Setup > Beeper > Beep Warning to switch the warning beeper on/off.

  3. Clicking Test Beep Warning allows you to hear and check the beep tone of the warning beeper.