FlexOTO Commands
FlexOTO Instance:
Hardware Diagram
Stations
The following table lists all FlexOTO commands and indicates if they can be sent to FlexOTO Hardware Diagram or to any running FlexOTO Station. Hardware Diagram and Stations are determined by the VISA address to which you send a command. When sending commands:
- Before Stations are started, all FlexOTO Hardware Diagram commands can be sent FlexOTO Hardware Diagram.
- After Stations are started (
:STARtroot level command), only some Hardware Diagram commands can be sent to FlexOTO Hardware Diagram. For example, after sessions are started: - You cannot send
:CONFiguresubsystem commands to alter the Hardware Diagram. - You cannot start a module calibration.
- You can send Common Commands and :DISPlay subsystem commands.
- You can sent the
:STOProot level command to end all Stations. - FlexOTO Station commands can only be sent to FlexOTO Stations and must be sent after FlexOTO Stations have been started.
